THE TIMER
Please note that this is a 24 hour clock, for exampleCookpot symbolBell symbol
2.00pm is shown as 1400.
In the following pages we explain how to set the
controls. Read through them a few times until you
are familiar with the procedure.
If the appliance is switched off on the wall, or there is
a loss of power, the clock will stop and you will not be
able to use the main oven. When you first switch the
electricity supply on, the timer display will flash.
SelectorSetting knob
TO SET THE TIME OF DAY
Turn the selector knob to ?Manual? then turn to ?Time
Setting?.
Set the correct time by turning and holding the setting
knob clockwise. Adjust the time by turning the
setting knob in either direction.
Turn the selector knob back to ?Manual?.
TO USE THE COUNTDOWN
Turn the selector knob to ?Countdown?. Turn the
setting knob clockwise until the display shows the
time you want. The bell symbol ( ) will be showing
and this will stay lit up during the time. Our diagram
shows the timer set to 5 minutes.
If you change your mind and want to cancel the time
you have set, simply turn the setting knob
anticlockwise. Then turn the selector to ?Manual?.
When you are using the 'Countdown' you can make
the clock show the time of day by turning the selector
knob to ?Manual?. The bell symbol will stay on to
remind you that the 'Countdown' is set. At the end of
the timed period an alarm will sound and the bell
symbol will go out.
Switch off the alarm by turning the selector knob to
'Time Setting'. Then turn to 'Manual' and the time of
day will show in the display.
Note:
You can use the countdown when an automatic
sequence has been set, as long as you remember
the following point.
1. Turn the selector knob to ?Automatic? as soon as
you have entered the timed period into the
display.
12 |
ACEC
